Tutorials
| Article | Date Sort ascending |
|---|---|
How To: Create a DesignThere are two ways to create a new design: Create it from scratch (starting with a blank schematic), or start with an existing design by first copying it as your own. Note that the terms "design" and "schematic" are interchangeable. Create a new design from scratch… |
January 20, 2020 at 9:57 AM by DGB |
How To: Work with GroupsOverview Groups are a new hub for collaboration. Our group framework provides a flexible, dynamic environment for users to engage in novel ways both with teammates and customers. Within a group, users have the ability to share and collaborate on designs and discussion boards, store relevant… |
January 20, 2020 at 9:56 AM by DGB |
How To: Change Component Property ValuesMost of the components from the PartQuest Explore component library allow you to specify property values (parameters) that will overwrite the default values. Some components like resistors, capacitors, inductors, and a few others, require that you add values. Components that require you to enter… |
October 17, 2019 at 10:54 AM by Mike Donnelly |
How To: Add Component ConnectionsWires (nets) can be added to component pins in multiple ways. You can: Click on a pin, hold and drag to another pin, then release Drag a component so its pin touches that of another component then release Right-click on an existing wire (net) and click on the new icon to add another… |
July 22, 2019 at 6:49 AM by Coop |
How To: Place a ComponentComponents are located on the left-hand side of the schematic editor. You locate the desired component by: Browsing the categories Using the Search field Once you locate the component, you can click on it and drag-n-drop it onto the schematic canvas. |
July 22, 2019 at 6:49 AM by Mike Donnelly |
How To: View Simulation ResultsPartQuest Explore "Waveboxes" are intended for very convenient yet powerful waveform viewing. You can add a wavebox as follows: Click on the Waveform Probe icon: This will bring up a wavebox and attach a probe to your mouse cursor. Drag the cursor to a schematic net and click to… |
July 22, 2019 at 6:45 AM by Mike Donnelly |
How To: Simulate DesignsOnce your design has been created you can run simulations on it to see if it's working as expected. This is extremely useful for both design/concept exploration as well as for working out design bugs prior to prototyping a design with actual hardware. Simulation preparation guidelines Following… |
July 22, 2019 at 6:45 AM by Darrell |