XAL6060-223 | PartQuest™ Explore

Test 1 Regular Inductor - Switching

Designer39271

Member for

9 years 3 months

11

designs

1

groups

Add a bio to your profile to share information about yourself with other SystemVision users.

Description

This design shows the importance of choosing the right inductor size and type, to avoid saturation-induced current spikes during operating transients. In this case, the start-up transient in two nearly identical open-loop buck power stages (12V -&gt; 3V) is examined. The only difference is that the top circuit is using an inductor calibrated to a Coilcraft XAL6060-223 (22uH), which has "soft saturation" behavior. The bottom circuit is using a similarly sized inductor, but with a more typical "hard saturation" characteristic. Both inductors work well for the steady-state load condition of 3 Amp. But during the turn-on transient, that current can go significantly above that nominal level. At that time, the instantaneous inductance of the hard-saturating device collapses, resulting in even larger current spikes in each switching interval. Note in the waveforms on the left: The soft-saturation inductance drops to 14uH minimum during the transient, whereas the hard-saturation inductance crashes to near 2uH, or only 10% of its nominal value!

About text formats

Compare Soft Saturation vs. Regular Inductor - Switching

Designer30

Member for

11 years 5 months

188

designs

1

groups

Add a bio to your profile to share information about yourself with other SystemVision users.

Description

This design shows the importance of choosing the right inductor size and type, to avoid saturation-induced current spikes during operating transients. In this case, the start-up transient in two nearly identical open-loop buck power stages (12V -&gt; 3V) is examined. The only difference is that the top circuit is using an inductor calibrated to a Coilcraft XAL6060-223 (22uH), which has "soft saturation" behavior. The bottom circuit is using a similarly sized inductor, but with a more typical "hard saturation" characteristic. Both inductors work well for the steady-state load condition of 3 Amp. But during the turn-on transient, that current can go significantly above that nominal level. At that time, the instantaneous inductance of the hard-saturating device collapses, resulting in even larger current spikes in each switching interval. Note in the waveforms on the left: The soft-saturation inductance drops to 14uH minimum during the transient, whereas the hard-saturation inductance crashes to near 2uH, or only 10% of its nominal value!

About text formats

Troubleshooting Terms of Use Cookie Notice Data Privacy Notice