power supply

Application Area

Designer229282

Member for

5 years 10 months

2

designs

1

groups

Add a bio to your profile to share information about yourself with other SystemVision users.

Description

This is a circuit design for a typical wall-plug power adapter.The sinusoidal source represents a typical US 60 Hz, 120V AC wall supply.A transformer steps the voltage down to a manageable range to be rectified for a 5V DC supply, but the waveform is still sinusoidal.The 4 diode bridge rectifier takes this lower amplitude sinusoidal signal and produces a DC biased result, but still with noise resulting from the rectification process.The capacitor before the voltage regulator chip helps smooth some of this noise. Then the regulator chip provides a self-contained, feedback controlled mechanism to keep the output voltage at the specified value.The output capacitor further smooths any output ripple and provides a reservoir of charge to supply any surge in current load that may be encountered.This example includes a load resistor that allows the exploration of the effects of load. The load is varied during the simulation and it can be seen that above a load of 100 mA, the regulation of the output voltage begins to deteriorate.The addition of a few components can make it possible for such a circuit to provide significantly higher power loads. See http://www.systemvision.com/design/ac-dc-power-adapter-current-boost-regulator for an example.

About text formats

Copy of Bridge Rectifier - on Wed, 01/29/2020 - 14:22

Designer201805

Member for

7 years 2 months

12

designs

1

groups

Add a bio to your profile to share information about yourself with other SystemVision users.

Copy of DC Power Supply - on Mon, 01/20/2020 - 20:50

Designer12

Member for

12 years

116

designs

10

groups

Add a bio to your profile to share information about yourself with other SystemVision users.

AC-DC Power Adapter

Designer197889

Member for

7 years 7 months

8

designs

1

groups

Add a bio to your profile to share information about yourself with other SystemVision users.

Description

This is a circuit design for a typical wall-plug power adapter. The sinusoidal source represents a typical US 60 Hz, 120V AC wall supply. A transformer steps the voltage down to a manageable range to be rectified for a 5V DC supply, but the waveform is still sinusoidal. The 4 diode bridge rectifier takes this lower amplitude sinusoidal signal and produces a DC biased result, but still with noise resulting from the rectification process.The capacitor before the voltage regulator chip helps smooth some of this noise. Then the regulator chip provides a self-contained, feedback controlled mechanism to keep the output voltage at the specified value. The output capacitor further smooths any output ripple and provides a reservoir of charge to supply any surge in current load that may be encountered.This example includes a load resistor that allows the exploration of the effects of load. The load is varied during the simulation and it can be seen that above a load of 100 mA, the regulation of the output voltage begins to deteriorate.The addition of a few components can make it possible for such a circuit to provide significantly higher power loads. See http://www.systemvision.com/design/ac-dc-power-adapter-current-boost-regulator for an example.

About text formats